Punch-Pin Fasten to Sheet Metal Without Drilling Now you can fasten light loads to sheet metal in less time than  it takes to drill a hole. This simple quick fastener is perfect  for attaching nameplates, wiring clips and small components  to metal doors, electrical cabinets, steel tubing etc.	Cross Section Of Punch Pin Set in Sheet Metal

Simple Application  Position the Punch-Pin on the tip of the tool, push the tool against the base metal and pull the trigger. The Punch-Pin is driven in a single impact. The fastening is fast and permanent. No Surface Preparation The hardened steel fastener drives through dirt, oil, grease and most  paints. Specially shaped annular grooves bite into the softer base  metal and form a permanent attachment which holds up to  250 pounds. No cleaning, no drilling. No Alignment Problems A Punch-Pin makes its own hole in the base metal so there is  never a problem aligning holes with base metal holes.

Tel/Fax: 01269 825980 / Mobile: 07548 507560   07944 803673 / fasteners2000@aol.com